Asus P5G41-M SI/VGA - Manual (Page 16)

DDR2-667MHz capability
SS - Single-sided / DS - Double - sided
DIMM support:
• A*: Supports one module inserted into any slot as Single-channel memory configuration.
• B*: Supports one pair of modules inserted into either the yellow or black slots as one
pair of Dual-channel memory configuration.
• C*: Supports four modules inserted into both the yellow and black slots as two pairs of
Dual-channel memory configuration.
Visit the ASUS website at www.asus.com for the latest QVL.
Vendor Part No. Size
SS/
DS
Chip
Brand
Chip No.
Timing
DIMM Voltage
DIMM Support
A* B* C*
A-Data M2OAD5H3J4170I1C53 2048MB DS ADATA AD20908A8A-3EG 30724 •
Apacer 78.91G92.9K5 512MB SS Apacer AM4B5708JQJS7E0751C 5 • • •
Apacer 78.01G9O.9K5 1024MB SS Apacer AM4B5808CQJS7E0751C 5 • • •
Corsair XMS2-5400 1024MB DS Corsair Heat-Sink Package 4 • •
G.SKILL F2-5400PHU2-2GBNT 2048MB(Kit of 2) DS G.SKILL D2 64M8CCF 0815
C7173S
5-5-5-15 • •
GEIL GX21GB5300SX 1024MB DS GEIL Heat-Sink Package 3 • •
GEIL GX22GB5300LX 2048MB DS GEIL Heat-Sink Package 5 • •
GEIL GX24GB5300LDC 2048MB DS GEIL Heat-Sink Package 5 • •
Kingston KVR667D2N5/1G(low
profile modules)
1024MB SS Elpida E1108AEBG-8E-F 1.8V • • •
Kingston KVR667D2N5/2G(low
profile modules)
2048MB DS Elpida E1108ACBG-8E-E 5 1.8V • •
PSC AL7E8F73C-6E1 1024MB SS PSC A3R1GE3CFF734MAA0J 5 • • •
PSC AL6E8E63J-6E1 1024MB DS PSC A3R12E3JFF717B9A01 5 • •
SAMSUNG M378T5263AZ3-CE6 4096MB DS Samsung K4T2G084QA-HCE6 • •
1.5 Expansion slots
In the future, you may need to install expansion cards. The following sub-sections describe
the slots and the expansion cards that they support.
Unplug the power cord before adding or removing expansion cards. Failure to do so may
cause you physical injury and damage motherboard components.
1.5.1 Installing an expansion card
To install an expansion card:
1.
Before installing the expansion card, read the documentation that comes with it and
make the necessary hardware settings for the card.
2. Remove the chassis cover (if your motherboard is already installed in a chassis).
3. Remove the bracket opposite the slot that you intend to use.
4. Align the card connector with the slot and press firmly until the card is completely
seated on the slot.
5. Secure the card to the chassis with the screw.
6. Replace the chassis cover.
Chapter 1: Product introduction 1-6