Asus M5A88-M - Manual (Page 69)

ASUS M5A88-M 3-19
Chapter 3
DRAM WRITE to READ Delay(SD) [Auto]
Configuration options: [Auto] [4 CLK] [5 CLK] [6 CLK] [7 CLK]
DRAM WRITE to WRITE Timing [Auto]
Configuration options: [Auto] [2 CLK] – [10 CLK]
DRAM READ to READ Timing [Auto]
Configuration options: [Auto] [3 CLK] – [10 CLK]
DRAM REF Cycle Time [Auto]
Configuration options: [Auto] [90ns] [110ns] [160ns] [300ns] [350ns]
DRAM Refresh Rate [Auto]
Configuration options: [Auto] [Every 7.8ms] [Every 3.9ms]
DRAM Command Rate [Auto]
Configuration options: [Auto] [1T] [2T]
3.5.10 DRAM Driving Configuration
The configuration options for some of the following items vary depending on the DIMMs
you install on the motherboard.
CKE drive strength [Auto]
Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x]
CS/ODT drive strength [Auto]
Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x]
ADDR/CMD drive strength [Auto]
Configuration options: [Auto] [1x] [1.25x] [1.5x] [2x]
MEMCLK drive strength [Auto]
Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x]
Data drive strength [Auto]
Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x]
DQS drive strength [Auto]
Configuration options: [Auto] [0.75x] [1x] [1.25x] [1.5x]
Processor ODT [Auto]
Configuration options: [Auto] [240 ohms +/- 20%] [120 ohms +/- 20%] [60 ohms +/- 20%]
Some of the following items are adjusted by typing the desired values using the numeric
keypad and press the <Enter> key. You can also use the <+> and <-> keys to adjust the
value. To restore the default setting, type [auto] using the keyboard and press the <Enter>
key.