Asus P5GDC Deluxe - Manual (Page 45)

A S U S P 5 G D C A S U S P 5 G D C A S U S P 5 G D C A S U S P 5 G D C A S U S P 5 G D C 1 - 3 5 1 - 3 5 1 - 3 5 1 - 3 5 1 - 3 5
1 0 . 1 0 . 1 0 . 1 0 . 1 0 . Chassis intrusion connector (4-1 pin CHASSIS1) C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 ) C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 ) C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 ) C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “GND” (Ground) are
shorted with a jumper cap. Remove the jumper caps only when you
intend to use the chassis intrusion detection feature.
P5GDC
P5GDC Chassis intrusion connector
CHASSIS1
+5VSB_MB Chassis Signal GND
(Default)