Zanussi ZFU420FW - Manual (Page 18)

4. Tighten again the screws.
2
4
3
1
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
To change the opening direction of the door, do these
steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the compressor
cannot touch the floor.
1. Remove the plinth.
2. Unscrew and remove
the lower hinges.
3. Remove the door.
4. Unscrew the upper pin
and screw it on the oppo-
site side.
5. Refit the door.
6. Make sure the edge of
the door is parallel with
the edge of the top.
A
B
7. Unscrew the pin (A) and
screw it on the opposite
side.
8. Remove the cap (B) and
position it on the opposite
side.
9. Screw the lower hinges.
10. Refit the plinth.
11. Stand the appliance
upright.
12. Fit the handle on the
opposite side and put the
plastic caps (contained in
the instructions bag) in the
free holes.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
18