Imetec SENSUIJ CM3-200 - Manual (Page 48)

43
ASSEMBLY/PREPARATION
• Unpack the product.
• Check that it is integral and undamaged.
• The massager pillow is supplied with Velcro securing straps making it possible to adapt it to the majority of
chairs available on the market. Pass the two straps (3) behind the chair back and secure them to each other
using the Velcro. If you prefer, simply rest the massager pillow on your chair or armchair.
• Connect the transformer to the massager pillow: insert connector (4) into connector socket.
• Connect the mains power supply (5) to the domestic mains.
ATTENTION!
The massager pillow is unsuitable for use in a car.
ATTENTION!
Never stand up on the appliance.
USE
Press the POWER button once to turn the massager pillow on.
Three types of massage can be selected:
• Energy
• Shiatsu
• Swing
ENERGY: vibration massage
• Press the ENERGY button to activate the vibration massage. The pillow will vibrate at minimum level and
the LED next to the letter (L) (Low vibrating level) will switch on. To increase intensity to (H) (High vibrating
level), press the button again and the corresponding LED will switch on.
• To deactivate the massage, press the ENERGY button after the (H) High level again.
SHIATSU
• Press the SHIATSU button to activate the massage.
• Press it again to deactivate it.
SWING
• Press the SWING button to activate the massage.
• Press it again to deactivate it.
Note: The two massages, SHIATSU and SWING, cannot be selected simultaneously. The Energy
massage can be selected simultaneously with the SHIATSU or SWING massage.
HEAT: heating function.
• Press the HEAT button to activate heat during the massage.
• Press it again to deactivate it.
Note: the HEAT function can be activated only after having activated the SHIATSU or SWING
massage.
• Press POWER again to turn the massager pillow off.
• After 15 minutes of treatment it is advisable to rest for at least 20 minutes.
• Disconnect the plug after use.
EN