Installation, Ardware, Nstallation – IPX DDK-1700BC User Manual
Page 11: Lacing a, Esiccant, Nside the, Ddk-1700bc, 11 2. installation
11
2. INSTALLATION
Follow the instructions and the diagram below to set up the system.
NOTE: The DDK-1700BC
’s Video Out connector can be connected to a monitor with via RCA
connection.
When connected you will see information on the monitor screen, including the
DDK-1700D
’s factory default IP address (192.168.1.168). The DDK-1700D’s IP
address will only appear if there is a connection between the DDK-1700D and
another device.
2.1 Hardware Installation
1.
If using external power, connect power adapter to the DDK-1700BC.
2.
Connect network cable to the DDK-1700BCs RJ45 connection.
3.
Confirm the correct network connection status.
4.
Enter DDK-1700BC
’s IP address into your browser.
2.3 Placing a Desiccant Pack Inside the DDK-1700BC
The DDK-1700BC comes with a desiccant pack which should be placed inside the camera using
two-sided adhesive tape. The desiccant pack is for reducing the moisture and humidity inside the
camera and prevents moisture from condensing on the lens or its cover.
If the user decides to remove the DDK-1700BC cover after more than a few months of use, the
used desiccant pack should be removed and place a replacement pack inside the camera.
1.
Adhere the desiccant pack to the inner side of the DDK-1700BC.
2.
Use two-sided adhesive tape to attach the desiccant pack.
3.
Reattach the cover of the DDK-1700BC.