Double Power Technology EM63 - Manual (Page 22)

Compliance Information
DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
This device is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Commu-
nications Commission of the U.S. Government.
The exposure standard for wireless mobile devices
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6W/kg. Tests for SAR are conducted
using standard operating positions accepted by the
FCC with the device transmitting at its highest
certified power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
device while operating can be well below the
maximum value. This is because the device is
designed to operate at multiple power levels so as
to use only the poser required to reach the network.
In general, the closer you are to a wireless base
station antenna, the lower the power output.
RF EXPOSURE INFORMATION (FCC SAR) The highest SAR value for the device as reported
to the FCC when tested for use when worn on the
body, as described in this user guide, is 1.23 W/kg.
(Body-worn measurements differ among device
models, depending upon available accessories
and FCC requirements.)
While there may be differences between the
SAR levels of various devices and at various
positions, they all meet the government require-
ment. The FCC has granted an Equipment Autho-
rization for this device with all reported SAR levels
evaluated as in compliance with the FCC RF
exposure guidelines. SARinformation on this
device is on file with the FCC and can be found
under the Display Grant section of www.fcc.gov/oet/
ea/fccid/ after searching on FCC ID: xx-xxx-xxx.
22