Lexibook DJA100 - Manual (Page 21)

21
ENGLISH
Button Guide
Image 1: The device without accessories
1. USB port
2. On/Off button + shutter release
3. Power LED indicator light
4. Speaker
5. Microphone
6. OK button
7. Up button / Wi-Fi button
8. Mode button
9. Menu button
10. Down button
11. LCD screen
12. Lens
13. Micro SD card slot
14. HDMI port
15. Reset button
Image 2: The device in the mount
16. Mount opening system
17. Mount base for helmet/bicycle mount
Image 3: Waterproof case + helmet mount + bicycle mount
18. Waterproof case (10 metres)
19. Helmet mount
20. Strap (for helmet attachment)
21. Bicycle mount
22. Yoke joint tightening screw
23. Camera attachment screw
24. Adjustment screw (camera positioning)
PRESENTING YOUR CAMERA
Unpacking the Unit
When unpacking the unit, ensure that the following pieces are
included:
1 x DJA100 digital camera / 1 x USB cable /
1 x Waterproof case / 1 x Helmet mount /
1 x Bicycle mount / 2x Adhesive fastener /
1 x “Move Cam App” card / 1 x User’s Manual
WARNING: All packaging materials, such as scotch tape, plastic
sheets, string and labels are not part of the product and must
be discarded.
PACKAGING CONTENTS
The lithium battery is intended for use only with this product.
Do not disassemble the battery. Do not dispose of the battery
in fire or water. To avoid risk of fire, burns, or damage to
your battery, do not allow a metal object to touch the battery
contacts. Handle a damaged or leaking battery with extreme
care. If it contacts the eye, flush the eye with water for 15
minutes and seek medical attention. Do not charge the
lithium battery pack if the ambient temperature exceeds 45°C
(113°F). When discarding a battery pack, contact your local
waste disposal provider regarding local restrictions on the
disposal or recycling of batteries. Only use the supplied USB
cable for charging.
WARNING: Malfunction or loss of memory may be caused by
strong frequency interference or electrostatic discharge. Should
any abnormal function occur, reset the unit and turn it on again.
Remark: Prior to using this camera for the first time, remove the
LCD screen’s protective film.
To recharge the internal lithium battery (1150 mAh), proceed
as follows:
1. Verify that the camera has been turned off.
2. Open the rubber cover shielding the USB port.
3. Plug the USB cable in the camera (5-pin) and in your
computer (4-pin). The power LED indicator light (3) lights up
red while batteries are recharging and shuts off once they are
fully recharged.
4. It is normal for the camera to become warm during
recharging, but unplug/turn off the device in cases of
overheating. Do not use the device while it recharges, nor use
cables other than those provided.
Remark: When the “low batteries” icon is displayed on the
screen, recharge them.
RECHARGING THE BATTERIES
Hold down the On/Off button (2) to turn on the camera. When
you turn on the camera, the power LED indicator light (3) lights
up. The device and its screen turn on to confirm that it is ready
to be used.
Long press the On/Off button (2) again to turn off the camera.
Remark: In order to conserve battery life, the camera goes on
standby after a few minutes of inactivity. Press the On/Off button
(2) to turn the camera back on. You can modify the “auto-off”
time under the “Automatic Shut-Off” option (see the chapter
“CONFIGURING THE DEVICE”).
TURNING THE CAMERA ON AND OFF
DJA100IM1363_6Sept_V06.indb 21 06/09/2013 5:38 PM