Lexibook ST100 - Manual (Page 3)

Copyright © Lexibook 2007
3
ENGLISH
Introduction
Congratulations! You have just purchased a Lexibook® Universal 10 in 1
Remote Control. Compatible with over 12,000 audio-visual device, this universal
remote control combines the functions of several remotes: TV1, TV2, DVD, CD,
Video Recorder 1 (VCR1), Video Recorder 2 (VCR2), Satellite (SAT), CABLE
TV (CBL), Amplifier (AMP) and Auxiliary (AUX). Digital TV receivers (like ADSL
modems, Freeview, DVB-T etc…) can be also controlled by the SAT key.
Caution: Before its first use, you must set up the remote control so that it
functions with your chosen audio-visual products. To do so, please read these
instructions carefully.
Installing batteries
Before programming and using your remote control, install 4 x AAA/LR03
alkaline batteries (not included). To do so, open the battery compartment located
at the back of the remote. Make sure to install the batteries according to the
polarity (+/- signs) indicated inside the battery compartment. Close back the
battery compartment.
Notes:
Your remote control will not lose its settings when the batteries are out of power.
When changing the batteries, do not press any key on the remote control. Else,
the remote control’s settings will be affected.
VCR1 – VCR selection
and set key.
AMP – Amplifier selection
and set key.
TV2 - TV2 selection
and set key (second
TV set).
VCR2– VCR2 selection
and set key.
M1/M2/M3 – Macro keys.
Using the buttons and functions
Once you complete the setup procedure, the Lexibook® Universal 10 in 1
Remote Control will allow you to control the various audio-video devices you
have at home. When you use the remote, first select the type of device you wish
to use by pressing the corresponding device key (TV1, TV2, DVD, CD, VCR1,
VCR2, SAT, CBL, AMP or AUX). Aside from the 10 device keys and the macro
keys, all other keys on the remote control are only operative if your device also
has these functions. For example, the pause key ( ), will work in DVD/CD mode
but not in TV1/TV2 mode.
SET – to trigger setting
mode.
LIGHT – to enable the backlight.
The red (R), green (G),
yellow(Y), and blue (B) buttons
can have various functions
depending on whether your TV
set supports these applications.
TV1 – TV selection and
set key.
SAT – Satellite TV
receiver selection and
set key.
DVD – DVD player
selection and set key.
AUX – Hi-Fi system
selection and set key.
CBL – Cable TV selection
and set key.
CD – CD player
selection and set key.
ST100.indd 3 4/9/07 18:05:16