Gardner Bender 960 Series How to Bend Guide - Manual

Gardner
Bender
Back-to-Back Bend
90˚ Bend
“Dog Leg” Bend or “Kick”
Leg Length
Offsets
Rise or “Stub-ups”
Segment Bend
Concentric Bends
6
1. ARROW
Indicates start of bend. Use for stubs and
saddle bends.
2. RIM NOTCH
Locates center of saddle bend.
3. STAR
Indicates the back of a 90° bend.
4. ANGLE ARROWS
Indicates the angle when bending on the
floor. (sighting down the bender)
5. DEGREE SCALES
Indicates the angle when bending in the
air. (sighting in-line with the conduit)
6. BEND BACK
Special channel designed for
correcting overbends.
7. CONDUIT VISE
Clamps conduit during cutting.
5
3
2
4
7
BENDING NOTES:
Thread handles into bender head as far as
they will go.
BENDING ON THE FLOOR:
For best results keep the conduit pinned to
the floor by applying constant pressure on
the foot pedal throughout the entire bend.
BENDING IN THE AIR:
Tuck the conduit under your
arm and use your foot to
keep the handle from
sliding on the floor. Keep
your hands and body
close to the bender
throughout the bend.
CORRECTING OVER BENDS:
There are two options for correcting
over-bends. One option uses the open
end of the handle as a “cheater” bar and
the second uses the hook area.
OPTION 1 OPTION 2
1
Benfield ® Style Hand Bender
How to Bend Guide
960 Series Benders
For instructions in Spanish and French please visit
Por favor, para instrucciones en Español y Francés visite
Pour des instructions en espagnol et français, veuillez visiter
www.gardnerbender.com