Gardner Bender CS400 Cylinder Support - Manual

IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspect all components for shipping damage. If any
shipping damage is found, notify carrier at once. Shipping damage is NOT covered by warranty. The carrier
is responsible for all repair or replacement costs resulting from damage in shipment.
Gardner
Bender
Instruction
Sheet
IMPORTANT USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must
be taken to select the proper components and design to insure appropriate integration with your operations
and existing equipment and that all safety measures have been taken to avoid the risk of personal injury
and property damage from your application or system.
The CS400 Cylinder Support is used only with the
Ultra Eegor™ models B400L and B400DL when
mounting them on the BE400 Table Assembly.
Weight of the B400L Cylinder and
Frame is approximately 125 lbs. Make
sure help or equipment is available to
lift the unit 3 ft high.
1. The B400L and B400DL bender assembly is
mounted to the top of the BE400 table. Position
the bender on the table; make sure the cylinder
is at the wheel end of the table. Slide the conduit
support extension under the cylinder. Raise the
extension up to support the cylinder during
assembly installation. Figure 1.
2. Remove the double anchor pin. Push on the
cylinder assembly to slide the cylinder and block
forward. Align the block with the holes marked
4” - 3
1 ⁄
2
”. Install the anchor pin. Figure 2.
3. Slide the front stabilizer bar over the side of the
table so the mounting bolts can be removed.
Leave the stabilizer in position. Move the cylinder
end of the bender to gain access to mounting
bolts connecting the round pads under the frame.
Remove each bolt. Position the lower frame and
pads over the holes in the table top.
GB ELECTRICAL, INC. CANNOT BE HELD RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY
UNSAFE USE, MAINTENANCE OR APPLICATION OF ITS PRODUCTS. Please contact GB's technical
service department for assistance if you are in doubt as to the proper safety precautions essential to
designing and setting up your particular application.
CS400
Cylinder Support
For Ultra Eegors TM B400L and B400DL
Fig. 1
Fig. 2