Gardner Bender CO2 CONDUIT FISHING SYSTEMS User Manual

Instruction sheet co2 conduit fishing systems

Advertising
background image

IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspect
all components for shipping damage. If any shipping damage is
found, notify carrier at once.

Shipping damage is NOT covered by warranty. The carrier is
responsible for all repair or replacement costs resulting from
damage in shipment.

Instruction

Sheet

CO2 CONDUIT

FISHING

SYSTEMS

IMPORTANT—USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must be taken to select the

proper components and design to insure appropriate integration with your operations and existing equipment and that all safety
measures have been taken to avoid the risk of personal injury and property damage from your application or system.

GB ELECTRICAL CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY UNSAFE USE, MAINTENANCE OR
APPLICATION OF ITS PRODUCTS.
Please contact GB ELECTRICAL for guidance when you are in doubt as to the proper safety
precautions to be taken in designing and setting up your particular application. To protect your warranty use only GB/Enerpac
hydraulic oil.

Model JO25C Power Pak II™ (5 lb. CO

2

System with Caddy)

Model JO25 Power Pak I™

Model JO250 Powr House™

(5 lb. CO

2

System)

(50 lb. CO

2

System)

Model JO220 Powr House™ (20 lb. CO

2

System) not shown.

INTRODUCTION

The GB/Jet Line Carbon Dioxide (CO

2

) Conduit Fishing Sys-

tems are high pressure tools which are used to place a pull line
in most conduit runs from

1

/

2

” through 6” diameter.

These systems are completely self-contained and no other
energy source is required. They are convenient to use in
remote locations and in new construction where there is no
temporary electrical power available or where only one or two
conduit runs are required.

Each system consists of five basic components:

• A high pressure gas (CO

2

) driving media.

• A control valve to start and stop the gas flow.

• Hose and seal-off to conduct the gas to the conduit and form

a seal at the conduit entrance.

• A line carrier to serve as a movable piston that supplies the

pulling force.

• Pull line for pulling wire through the conduit or to pull in a

rope or cable for large difficult runs.

A thorough understanding of all components and their function
and operating precautions is essential for safe and efficient use
of the system.

Read all of the instructions before attempting to use the system
or blow line in the Conduit.

IMPORTANT SAFETY INSTRUCTIONS

Wear a hard hat, eye
protection, and gloves.

When using a carbon dioxide
conduit fishing system basic
precautions should always

be followed. FAILURE TO OBSERVE THESE INSTRUC-
TIONS COULD RESULT IN SERIOUS INJURY OR DEATH.

Do not discharge a cylinder
containing carbon dioxide
(CO

2

) in a non-ventilated

manhole or other non-ventilated areas. Carbon dioxide is rela-
tively inert, but is heavier than air and will displace it and accu-
mulate in depressions and along the floor. Concentrations of

Advertising