Hach-Lange LDO Air Blast Head, Guard Head Installation - Manual

HACH COMPANY
WORLD HEADQUARTERS
Telephone: (970) 669-3050
FAX: (970) 669-2932 FOR TECHNICAL ASSISTANCE, PRICE INFORMATION AND ORDERING:
Call 800-227-4224
Contact the HACH office or distributor serving you.
www.hach.com [email protected]
In the U.S.A. –
Outside the U.S.A. –
On the Worldwide Web –
; E-mail –
toll-free
DOC306.53.00802
Instruction Sheet
LDO Air Blast Head, Guard Head Installation
1. Loosen the two allen head cap screws using the allen wrench supplied with the kit. Slide
the air blast cleaning head or the guard head on the sensor body.
2. Push the head onto the sensor body (Figure 1, item 3).
3. Tighten the allen head capscrews. Do not overtighten. Refer to the Air Blast manual for air
hose connections, where applicable.
Figure 1 Air blast head and sensor guard head components
1 Sensor body 5 Air hose assembly (not supplied with kit)
2 Air blast cleaning head assembly (Cat. No. 6190250) 6 Guard head assembly (Cat. No. 6184750)
3 Assembly detail. 7 Allen head cap screw (2 assembled) 6-32x1 in.
( Cat. No. 010293)
4 Elbow (Cat. No. 6172200) with quick-connect fitting
(Cat. No. 4H1314)
8 Allen wrench (Cat. No. 5134500)
© Hach Company, 2007. All rights reserved. Printed in the U.S.A. Edition 1, April 07 eac/dk