DoorKing 1838 Multi-Door Access Controller - Manual (Page 33)

3.4.3 Programming Area Code
Program an area code when 10-digit or long distance calling is required. You can program up to 10
area codes, but since the 1838 can only dial three phone numbers, only three will be used. The area
code will be entered as a four-digit number (1 + the three digit area code) for long distance dialing. If
an area code is being programmed to facilitate 10-digit calling requirements, precede the three-digit
area code with #. To program different area codes, you will use a different area code reference
number, 0 through 9, entered in step 2 below. We suggest using 1 for the first area code reference
number, 2 for the second, 3 for the third and so on. Use 0 for the tenth reference number.
1. Press * 2 4 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the area code reference number (0 – 9) _ then press * (beep).
3. Enter the four digit area code _ _ _ _ then press * (beep). NOTE-1: for long distance
calling requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit
calling requirements, enter # and the three-digit area code.
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.4 Programming Phone Numbers with Area Code
In this section, phone number is referenced to the area code that was programmed in 3.4.3.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.4.2.
1. Press * 4 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Enter the area code reference number (0 – 9) _ then press * (beep).
4. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number
that you are entering in this step is less than seven-digits, enter # in the empty
spaces. See 3.4.2, step 3.
5. Press 0 # TOGETHER to end this programming step (beeeeeep).
1838-065-U-4-13 Page 33