Lectrosonics Quadra - Manual (Page 10)

QUADRA
LECTROSONICS, INC. 10
Master(1,2) mode
AUDIO CH.
1 2
NO
FUNCTION
NO
FUNCTION
MASTER
VOLUME
MASTER
VOLUME
AUDIO
CH. 1 NO
FUNCTION
Master (1)+2 mode
AUDIO
CH. 2
NO
FUNCTION
AUDIO
CH. 1 NO
FUNCTION
1+2 mode
AUDIO
CH. 2
NO
FUNCTION
Split 1,2 Operation
Split modes allow you to use a single M4T transmitter
running in the 4 Channel mode to send two different
2 channel stereo mixes to two different receivers or
groups of receivers using a single radio frequency.
Split 1+2 mode delivers audio channels 1 and 2 to
the tall, thin knob and the lower concentric knob. The
knobs can be set up to function in three different ways.
NOTE: the transmitter must be in 4 Channel
mode for the receiver to work in this manner.
• Master(1,2)
Equivalent to standard IEM systems where only
stereo signal is used. The tall, thin knob is the ste­
reo master volume and is fed from audio channels
1 & 2. Although there is audio on channels 3 & 4
in the transmission itself, they are muted and thus
the lower main knob and two individual knobs do
not function.
• Master(1)+2
Feeds audio channel 1 to the master volume (tall,
thin knob) and audio channel 2 to the lower con­
centric knob for independent control.
• 1+2
The two knobs function independently with neither
one working as a master. Feeds audio channel 1
to the tall, thin knob and audio channel 2 to the
lower concentric knob for independent control.