Lectrosonics DMPA12 - Manual (Page 4)

DMPA12 Installation Guide
LECTROSONICS, INC. 4
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio commu-
nications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
CAUTION: Changes or modifications not expressly approved by Lectrosonics, Inc. could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Table of Contents
Important Safety Instructions................................................ 3
Introduction ............................................................................. 5
Unpacking the Unit ................................................................ 5
Items Included in the box: ..................................................... 5
Hardware Installation ............................................................. 6
Rack Installation .................................................................... 6
Cables and Power Cord ........................................................ 6
Audio Inputs ......................................................................... 6
Speaker Outputs ................................................................... 6
DMPA12 Rear Panel ............................................................. 8
Programmable Inputs ............................................................ 8
Programmable Outputs ......................................................... 8
Programmable Inputs and Outputs Wiring ............................ 9
Control System Interconnections .......................................... 9
Installing LecNet2 Software and USB Driver ..................... 10
Installation with LecNet2 Device Installer ........................... 10
Manual Installation .............................................................. 11
Initial Setup ........................................................................... 13
Connect ............................................................................... 13
Select the Signal Source ..................................................... 14
Initial Setup Hints ................................................................ 15
Additional Settings and Functions ..................................... 16
Compressor and Limiter ...................................................... 16
Front Panel Gain Controls ................................................... 16
Front Panel Output Activity Indicators .................................. 17
Output Fault Indications ...................................................... 17
Expansion Mode Setup ....................................................... 17
RS-232 Baud Rate Adjustment ........................................... 17
Connect Options ................................................................. 18