Manual installation – Lectrosonics DMTH4 User Manual
Page 12
DMTH4
LECTROSONICS, INC.
12
Accept, then click
Next to proceed.
The drivers are installed from the CD. When installation
is complete, the final page of the installer will appear.
The
Driver Name and Status are displayed. Click on
Finish to close the installer. You may new connect any
LecNet2 device to the PC and drivers will be loaded
automatically.
Manual Installation
If the USB drivers have not been pre-installed on a PC
prior to connecting a LecNet2 device for the very first
time, you may install the manually if you wish.
On Windows XP and Vista operating systems, the
Found New Hardware Wizard will open when the de-
vice is detected. It will walk you through the process of
installing the LecNet2 drivers. To proceed, you will need
the LecNet2 Installation Disk. Click on the following link
and follow the instructions:
On Windows 7 operating systems, the system attempts
to find a driver automatically when the device is de-
tected. If it cannot find one, it notifies the user that driver
installation failed. In this case, the Windows
Device
Manager is used to install the drivers. To proceed, you
will need the LecNet2 Installation Disk. Follow these
instructions: