Front panel, Dual - channel ready – Lectrosonics Long Ranger II User Manual
Page 5
OFF
RF
12V DC
OUTPUT
CHARGE UNTIL
LAMP GOES OUT
CH-40
CHARGER
POWER
AUX IN/OUT
MIC
LINE
WIRELESS
MICROPHONE
VOLUME
AUXILIARY
INPUT
VOLUME
MOD
LEVEL
R
S
E
I
C
R
P
6
U
I
K
H
T
DUAL - CHANNEL READY
EXTERNAL 8 OHM SPEAKERS
LOWER JACK DISCONNECTS MAIN HORN
12V DC
EXTERNAL POWER
LECTROSONICS
RIO RANCHO, NM
MADE IN USA
FRONT PANEL
12V DC POWER INPUT
A special jack used to connect an external 12 Volt DC source to the unit to substitute for the "on-board"
battery pack. It is most commonly used for connecting the LONG RANGER II to a vehicle cigarette
lighter receptacle. When an external power source is connected to this jack, the on-board battery pack
is automatically disconnected.
EXTERNAL 8 OHM SPEAKERS
Two jacks which are used to connect external 8 ohm horns or speakers such as the Lectrosonics H300
horn or ES300 column speaker.
EXTERNAL ANTENNA
A standard BNC connector provided to allow the use of an external antenna if required. It is suggested
that you contact the factory for technical assistance if you plan to use the LONG RANGER II in an
operational environment where an external antenna might be needed.
Figure 2 - Control Panel
Figure 3 - Front Panel
4