Lightronics TL5024 - Manual (Page 9)

www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 tel 757 486 3588
Page 9 of 13
TL-5024 LIGHTING MEMORY CONSOLE
Version 0.93
OWNERS MANUAL
07/20/2012
5. ERASE ALL: Performs all 4 of the erase
functions
described above.
USING ERASE FUNCTIONS
1. Push ENTER ENTER . The
display will show the ERASE CUEING menu.
2. Push ENTER to erase the cues. or Push to
move to the next erase function.
Once in the erase menus you can use the and
buttons to cycle through all of the erase function
choices. When you activate an erase function you will
see a display (shown below) which allows you to back
out without actually completing the erase function.
The N means NO. Use the button to change it to Y
(yes) and push ENTER. The function will proceed.
DMX OPERATION
If the DMX option is installed in the TL-5024 it will
transmit both DMX and LMX signals simultaneously.
The DMX-512 connection does NOT provide console
power therefore an external power supply (provided
with units having the DMX option) must be used.
TL-5024 WIRELESS OPTION
The TL-5024 can optionally be provided with an
internal RF transmitter module which transmits the
DMX-512 control signal. It can operate with multiple
compatible wireless DMX dimmers and/or receivers.
The receiver units get the same information they would
get using a cable connected to the TL-5024 DMX
connector.
The wireless system uses the 2.45 GHz band and
operates at low power (< 100mW). The operating
range is approximately 1400 ft. indoors and about
4000 ft. for outdoor operation. This range could vary
significantly depending on the surrounding conditions.
A link between a specific wireless TL-5024 and one or
more compatible receiving units must be invoked to
enable wireless operation. The link operation is done
at the TL-5024. Once linked, the receiver units can
operate ONLY with that specific console.
The link is retained even when the receiver and/or
console are powered off. The receiver units may be
released from the link either at the TL-5024 or at the
receiver. If released at the console then ALL linked
receivers will be released. If released at the
receiver then ONLY that receiver will be released.
ANTENNA CONNECTION
Carefully thread the antenna to the gold antenna
connector on back edge of the unit. It should be
finger tight only. The connectors can be damaged
or jammed if too tight. The antenna will swivel to a
convenient orientation while connected.
WIRELESS OPERATION
A small pushbutton and a LED are located to the left
of and below the main console LCD display. The
button controls all wireless operation. The LED
indicates wireless status.
STATUS INDICATOR LED
The indicator shows wireless status as follows:
OFF No wireless power
ON Transmitter ok
FLASH Linking in progress
OR
Link release in progress
LINK CONTROL BUTTON
This pushbutton switch is used to link all free
receiver units within its range. It is also used to
release the links with all receivers in its range.
LINKING RECEIVERS
LINKS WILL NOT BE MADE WITH RECEIVERS
ALREADY LINKED TO ANOTHER TRANSMITTER
DEVICE.
Push the link control button once (do not hold
down). The indicator LED will flash for about 10
seconds. It will then go to an ON state.
The link indicator on the receiver will also flash and
may continue this for several more seconds after
the console indicator goes back to ON. The
receiver link indicator will go to an ON state when
the link is stable.
Are You
Sure? N