AT&T 847868304 User Manual
Part 2
Advertising
User's Manual
for Cordless Answering
System Telephone 7610
Fold open this manual for information about this
telephone's installation and operation. Please
read Part 1 – Important Product Information,
included in this package
Part 2
© Copyright 1997 Lucent Technologies, Inc. All rights reserved.
Printed in Mexico. Issue L4
847868304
CHARGING
HANDSET IN USE
MEMO/REWIND
SA
VE
CLOCK
VOLUME
FAST FWD
PLA
Y/ST
OP
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- INSTALLATION
- 1. Insert the microcassette.
- 2. Choose a spot near an electrical outlet and a telephone jack.
- 3. Install the handset battery.
- 4. Set the Handset Ringer ON/OFF switch.
- 5. Connect the telephone line cord.
- 6. Mount the base on the wall (WALL MOUNTING ONLY)
- 7. Connect the power cord.
- 8. Charge the handset batteries before use.
- 9. Check for dial tone.
- 10. Set the dial mode.
- BATTERIES
- IN CASE OF DIFFICULTY
- If the phone does not work at all, check these items first
- If you hear a two-beep signal when you try to use the handset
- If you have no dial tone,
- If you hear noise or interference when using the phone
- If the phone does not ring when you receive a call
- If your telephone misdials or you don’t hear the other person right away
- If the Message Light flashes rapidly
- If you have difficulty hearing messages
- If the recording tape sticks or malfunctions
- If the system does not answer after the correct number of rings
- If the system does not respond to remote commands
- OPERATION
- MEMORY
- OPERATING RANGE
- ANSWERING SYSTEM OPERATION
- Volume Control
- Recording Your Announcement
- Turning the System On and Off
- Setting the Clock
- Ring Select
- Answering Calls
- Bypassing the Announcement
- Message Light
- Listening to Your Messages
- Recording a Memo
- Call Screening/Intercept
- When the Tape is Full
- Changing the Microcassette
- FROM A REMOTE TOUCH TONE PHONE
- IMAGES