SecurityMan AVLCD - Manual (Page 13)

3) Set the camera to desired Channel, and place the camera at
desired location.
4) Press the Channel button on the receiver until the Channel LED
indication match to the channel on the corresponding camera, and
the LED monitor will display pictures. If you cannot set the channel
by pressing the Channel button, please check the settings of mode
control. (Please refer to Mode Control Setup section for more detail)
ON
OFF ALARM ON
ALARM OFF
1 2 3 L
CH1 CH2 CH3
SNOOZE CHANNEL
Channel button Control Mode
Push
Push
DC8V
ON/OFF
DC8V
ON/OFF
1 2 3
CH1: 2,414MHz
CH2: 2,432MHz
CH3: 2,468MHz
PIR Motion
Sensor
Audio
Sensor
OFF PIR Motion
Sensor
Audio
Sensor
OFF
13