Sonnet Technologies Echo Express SE Thunderbolt Expansion Chassis - Manual (Page 8)

4
Chapter 3 – PCIe Card Installation Steps
Figure 1
1. Remove the Echo Express SE chassis from its packaging, and then set it
upside-down on a soft, flat, level surface.
2. Remove and set aside the two screws securing the bottom of
the outer case to the inner assembly (Figure 1).
3. Turn the Echo Express SE chassis right-side-up, with the back facing
you (Figure 2).
4. Remove and set aside the two screws securing the
back edge of the outer case to the inner
assembly
(Figure 2).
5. Without squeezing it, place your hand on top of the
outer case. Remove the inner assembly by gently
grasping its faceplate by the edges and
pulling
(Figure 3). Set aside the outer
case.
Support Note: To avoid damaging components
due to static electricity discharge, wear an antistatic
wrist strap while working inside Echo Express SE.
Figure 2
Figure 3
Inner
Assembly
Outer
Case