Gilderfluke&Co Video Chameleon - Manual (Page 4)

4
Setup & Connections:
The Video Chameleon player is connected much as a VCR or DVD
player, except that it requires DC power. Mandatory connections in-
clude DC power, CompactFlash card with playable files, video cable
and (if required) audio cable. Optional connections include Serial
(RS232), Ethernet (10BaseT) and User Interface.
Connection Sequence:
The CompactFlash card must be in place when power is applied to the
player. Although no harm will occur to the player, the player cannot
boot without the card in place. There is no on-off switch, so boot starts
when power is applied. Bootup takes about 30 seconds while the player
accesses the files. There will be no image on the screen during bootup.
The CompactFlash card cannot be changed with the power applied.
Again, no harm will come to the player, but the new card may not boot
and play until power is removed and reapplied.
Sequence Summary:
1. Connect all cables except power
2. Install CompactFlash card
3. Connect power
DC In RS232 Audio Out
User Interface
Ethernet
Ethernet LED
Power On LED
Memory Card
+ -
Composite Video
S-Video
Made in USA
Model Serial #
Complies with FCC and EC commercial use standards Read operating instructions prior to installation
No user serviceable parts inside
www.videochameleon.com
DC In RS232 Audio Out Video Out
User Interface
Ethernet
Ethernet LED
Power On LED
Memory Card
Input: 7-25 VDC, 3.6 W + -
Connector Layout Diagram