LED LENSER SEO™ 7R - Manual (Page 5)

04
GB
- The Light Program White (see Point 5.1) is
activated
9. Charging
The SEO 7R indicates by the flashing of the
red LED that it is running out of energy in near
future. Please charge the Accumulator-pack
in time. Charge the Accumulator-pack of your
SEO 7R in a dry place and only by using the
charger that is included in the delivery or by a
USB port (see below).
The following information applies only to the
included accessories. You cannot charge any
other accumulators or batteries in the SEO
7R. In case NiMH-Accumulators (see Point 1)
are used, they must be charged in approved
external chargers.
In the scope of delivery of the SEO 7R there
is a plug and a charger. In case both are not
connected already please connect them so that
the connection clicks.
The charger of SEO 7R has a USB port, which
must be connected with the corresponding
port at the supplied charging cable in order to
charge Accumulator-pack. The other side of the
charging cable (micro USB) must be connected
to the Accumulator-pack which is scope of
delivery. You will therefore have to open the
battery box. The supplied Accumulator-pack
has two charging ways, either it loaded in the
battery box of SEO 7R or can be removed out of
the battery box for charging. Only the supplied
Accumulator-pack can be charged with the
charger.
The last step is to connect the plug into a
socket (Input: 100 V to 240 V / 50 Hz to 60 Hz).
When charging is completed (after maximum 2
to 3 hours), unplug the charger from the socket
again and the charging cable (micro-USB) of
the Accumulator-pack. But it is no problem to
go on loading the Accumulator-pack although it
is already full.
Instead of connecting the charging cable to the
USB port of the charger, you can also connect
it to a different USB port (5 V / 900 mA) e.g. of a
computer.
While using our optionally available car USB
charger connection (Led Lenser Car Charger:
Item no. 0380), the SEO 7R also can be charged
at the cigarette lighter and sockets in vehicles.
These accessory units match themselves
automatically to the respective input voltage
(12 V / 24 V). These alternatives are suitable to
charge the Accumulator-pack in case a power
outlet is not available.
Note – Please ensure that there is no short-
circuit at the charging contacts. The charging
contacts may not be touched with moist or
metallic objects.
10. Charge indication
In case you are charging the Accumulator-Pack
of the SEO 7R with the corresponding charger
and charging cable respectively by a USB port
(see Point 9) the status LED at it glows while
charging in red and the light changes to green
when the charging is completed.
11. Changing of the Accumulator-Pack /
NiMH-Accumulator / Alkaline batteries
Prior to the change, please turn off the SEO 7R.
On the wide side of the head lamp housing
there is the cover of the battery box. Nearby
the switch button there is a plastic lip. If this lip
is carefully pressed with e.g. your thumb up a
little, the battery box cover can be folded down
by using the small notches that are left and
right next to the switch button.
You can now remove the Accumulator-Pack
(Alkaline batteries / NiMH-Accumulators) and
insert a new one.
Also NiMH-Accumulators and alkaline batteries
can be inserted.
But then the charger cannot be used!
During insertion, it is always necessary that
this is in the correct direction. Therefore, pay
attention to the polarities (+ and -). Both in
the battery box and also on the Accumulator-
Pack / NiMH-Accumulators / alkaline
batteries. Otherwise, the hypothetical risk that
Accumulators / batteries are damaged and
may explode.
The supplied Accumulator-Pack can only be
recharged with the original charger or by a
USB port (see Point 9)!
After replacing the cover of the battery box has
to be closed again.
12. Headband
If the headband is not already connected to the
lamp unit, proceed as follows.
Thread the end of headband with the narrow
plastic part from the front through the eyelet
on the left side of the head lamp housing.
Note the orientation of the lettering on the
headband. Run the headband then over the
cover of the battery box to the eyelet on the
other side of the battery box and run it through
it to the front.
This end of the headband has got to be pulled
through the hole beside the clipper at the
plastic part on the other side of the headband.
This elongate hole has got 4 small bars
through which the narrow plastic part has to
be run from the side.
This allows that the complete end is pulled
through this hole and both ends of the
headband are connected to each other.
By using the eye of the clipper the SEO 7R can
e.g. attached to an ear of a belt or a backpack
for transportation.
The third plastic component at the headband
can be used to adjust the length of the
headband in order to fit different head
circumferences.
13. Rechargeable batteries / Accumulators
Non rechargeable batteries or other
accumulators that are not of the same type
as the accumulator that is scope of delivery
are not allowed to be charged by the charger.
Never use non rechargeable batteries and
accumulators together. Change always all
nonrechargeable batteries and accumulators
at the same time. Use in the SEO 7R only the
Accumulator-Pack (scope of delivery), alkaline
batteries AAA/LR03/Micro (1.5 V DC) or NiMH-
Accumulator AAA/LR03/Micro (1.2 V DC).