LevelOne KVM-1631 - Manual (Page 18)

13
5. On Screen Display
User can control the KVM switch by three ways – front panel Control Buttons, OSD
(On-Screen Display), or Hot key commands through the Console keyboard. It takes
approximately 1-2 seconds for the video signal to refresh after switching computers.
Re-synchronization of the mouse and keyboard signals also occurs. This is normal
operation and ensures that proper synchronization is established between the Console and
the connected computers
Hotkey
You can conveniently command KVM switch through a simple hot key sequence. To send commands to KVM
switch, you must press the hotkey (
default Caps Lock) twice within 2 seconds. You will hear a beep
sound confirming entering Hotkey mode. If you do not press any key during Hotkey mode over 2 seconds the
Hotkey mode will be escaped and back to Normal state. The default hotkey is Caps Lock but you can change
hotkey as your application convenience. If you prefer to use other hotkey, please go to OSD menu and
change the default hotkey to the other.
Note: OSD accepts capital letters only. (Uppercase)
Command Function
Space bar Bring up the OSD overlay screen
В В В В Moving up
Г Г Г Г Moving down
[1,2,..,8] bank,
[01, 02,..,32] port
■ The first digit is bank number starting with “1”. The KVM switch on the
Daisy chain line is on bank 1 (the Master). A standalone KVM switch also
on bank 1.
■ The second & third digits are port number starting with “01”
PgUp Previous bank
PgDn Next bank
B Turn beep sound on/off
L
To enable/disable the Screen Saving function and 10min auto-logout
function. This function is default OFF (Disable).
P
To log out the OSD. If Security is enabled it will show up the Login window
waiting for username and password. If Security is disabled it will show up the
Status window
R
For SUPERVISOR to set the OSD back to factory default value (except User
Security settings).
S For SUPERVISOR to activate the Auto-Scan function
U For SUPERVISOR to turn Security function on/off. If the Security is off, we