LockeyUSA M230 DC - Manual

Step 5: Verify Correct Spindle Length
1. With latch (#13) installed, hold
the Inside Body (#2) and Rubber Trim
Plate (#3) to the door.
2. Place Spindle (#6/7) through latch, into
the Inside Body, as far as possible.
3. Spindle should extend from exterior of door
3/8” min. – 5/8” max.
4. If the 30-45 mm (#7) is too long, cut it to the correct length.
IMPORTANT: If spindle extends less than 3/8” it may not engage the lock. If spindle
extends more than 5/8”, it will cause the lock to bind.
Step 6: Determine Knob Turn Direction (to unlock)
The lock is preset to unlock when turned clockwise after combination is
entered.
If desired, you can unlock the door with a
counter-clockwise turn. Remove the two
blue screws and move the pin to the
opposite side as shown.
*M230 DC – Inside Body pin must on opposite side from Outside Body.
No. Part Name M230
1 Outside Body 1
2 Inside Body 1
3 Rubber Trim Plate 2
4 Mortised Strike 1
5 Strike Plate 1
6 Spindle 40-55 mm. 1
7 Spindle 30-45mm. 1
8 Machine Screw M4 x 50 mm. 2
9 Machine Screw M4 x 35 mm. 2
10 Wood Screw M4 4
11 Extra Code Tumblers (Red) 1
12 Extra Non-Code Tumblers (Blue) 2
13 Adjustable Latch 2 3/8” – 2 3/4” 1
14 Tweezers 1
15 Hex Bolts 2
16 Brass Support Pin 1
Door Edge
Step 7: Install the Lockey M230
1. Place the Rubber Trim Plate (#3) on the
backside of the Outside Body (#1).
2. Place the Outside Body
on the door. The hexagonal
bolts (#15) should extend
into the top and bottom holes.
3. The Support Pin (#16) on the Inside
Body should fit into and extend through
the hole in the Latch (#13).
INSTRUCTIONS CONTINUED ON REVERSE SIDE
Step 4: Install Support Pin & Hex Bolts
Install Brass Support Pin (#16) into Inside
Body as shown in the figure to the
Right [Left].
Install/screw Hex Bolts (#15) into the top
and bottom of the Outside Body
as shown in the figure [Far Right].
Step 3: Adjust Latch (if necessary) & Install
1. Adjustable latch (#13) is factory preset for a 2 3/8” backset.
2. For 2 3/4” backsets, slide the Cam assembly on the latch to 2 3/4”.
3. Insert latch into door and secure with Wood Screws (#10).
Lockey M-230 | M230 DC
Installation Instructions
Step 2: Prep Door for Installation with Template
1. Place template (supplied) on door and fold along door’s edge.
2. Mark holes for 2 3/8” or 2 3/4” backset.
3. Drill holes as instructed.
NOTE: For Pre-Prepped 2 1/8” doors, you only need to drill top hole.
Inside Body (#2)
Spindle (#5/6)
3/8” to 5/8”
Step 1: Change User Code (OPTIONAL)
If you wish to change your code, see instructions on reverse side.
Thumb-Turn
Inside Body Outside Body
2 3/8”
2 3/4”