Luxor|H.Wilson WFST - Manual

M5x16 mm (x4 each)
M6x16 mm (x4 each)
M8x35mm (x4 each)
Right Hook
Bracket(x1)
Wall Plate(x1)
TOOLS REQUIRED:
Power Drill
1/4” or 1/2” Drill Bit
Phillips Head Screw Driver
Spirit Level
WFST Installation Instructions
" "
" "
0 0 2 8 . 0 9 3 6
THE WARRANTY WILL ONLY BE VALID IF YOU FOLLOW THE INSTRUCTIONS CAREFULLY.
Please do not begin installation until you have thoroughly read and understood these instructions.
Improper installation may cause serious injury and/or damage. It is recommended that a qualified
contractor install the WFST Universal Tilted Wall Mount.
Make sure that the wall you plan to use will safely support four times the combined weight of the
mounted equipment, including its accessories.
The WFST Universal Tilted Wall Mount supports LCD and Plasma Flat Panel Displays
from 37 to and supports a maximum load of kg lbs
This products suits displays with 800mmx500mm(32 x20 mounting hole patterns
A second person will be required to assist with several steps.
The manufacturer does not accept responsibility for incorrect installation.
( ).
. )
37”-63” Universal Flat Panel Display Tilted Wall Mount
Left Hook
Bracket(x1)
Lag Bolt
8*70mm(x4)
Anchor(x4)
Spacer (x4)
TIP:
Use a spirit level to
ensure the wall plate
is horizontal.
IMPORTANT:
Tighten lag bolts so that wall plate is firmly attached to wall,
but DO NOT over tighten. The lag bolts can be damaged by
over tightening which will strip their threading.
Final tightening oflag bolts should be done by hand using
a ratchet wrench and socket.
Lag bolt
8x70mm
13mm(½”)
Hole
Wall Anchor
TIP:
Use a spirit level to
ensure the wall plate
is horizontal.
Timber Stud
6mm(1/4”)
Hole
Lag bolt
8x70mm
Metal washer (x4) Ш6
11/6/13
1 / 2