Staub Electronics WPS-550-BUL-A WIREPATH - SURVEILLANCE 550-SERIES BULLET ANALOG OUTDOOR CAMERA WITH IR (600 TVL) - Manual (Page 9)

9
WPS-550-BUL-A Installation Manual
© 2013 Wirepath Surveillance
4. Fine-Tuning Camera Adjustments
The Camera is equipped with a BNC Test Port that allows for local Analog Video
output and power to the Camera for adjusting positioning, zoom, and focus.
The camera is supplied with an OSD Joystick / BNC Test Adapter that allows
for viewing the output of the camera on a monitor or the WPS-CCTV-TESTER
(not included). Use this connection to adjust the camera directly from the
installed location.
Adjust Zoom
Adjust Focus
BNC Test Adapter
Connection
A. Remove the plate located at the rear of the Cameras just before
the Cameras base to access the OSD Joystick / BNC Test Adapter
connection.
B. Connect the OSD Joystick / BNC Test Adapter to the Camera.
C. Connect the BNC on the adapter to a monitor or WPS-CCTV-TESTER
video in.
D. Connect a 12 V DC Power Supply to the Power connection on the OSD
Joystick / BNC Test Adapter if no other power connection is active.
Warning!! The Test Port adapter power connection for this camera only uses a 12 V DC
power supply. Using a 24 V AC or other voltage power supply with the Test Port Adapter
will result in damage to the camera, and possibly the power supply.
E. Adjust the Cameras Rotation, Swivel, and Angle as defined in step 1 and
secure the set screws using the supplied 3mm Allen key.
F. Adjust the Cameras Zoom (furthest from the lens) using the supplied
3mm Allen key.
G. Adjust the Cameras Focus (closest to the lens) using the supplied 3mm
Allen key.