Vortexx Pressure washers - Manual (Page 7)

Owner’s Manual Owner’s Manual
7
How to Start Your Pressure Washer
To start your pressure washer for the first time, follow these instructions step-by-step. This starting
information also applies if you have let the pressure washer sit for more than 24 hours.
• Make sure unit is in a level position.
• Check that the high pressure hose is tightly connected to the spray gun and to the pump.
• Check that the garden hose is connected to the water inlet on the pressure washer pump.
Turn the water on to maximum flow.
CAUTION! DO NOT run the pump without the water supply connected and turned on. You must follow
this caution or the pump will be damaged.
• Squeeze the trigger on the spray gun until you have a steady stream of water.
This purges the pump of air and debris.
• Apply the safety latch to the spray gun trigger. (Figure 2)
• Start the engine according to the engine owner’s manual.
NOTE: If the recoil starter is hard to pull, release the safety latch, squeeze the spray gun trigger to
relieve internal pump pressure and reset the safety latch before attempting to start again.
How to Stop Your Pressure Washer
• Turn engine off according to the engine owner’s manual.
CAUTION: Shutting off the engine will not release pressure in the system. Point the gun away from
objects that can be damaged and squeeze trigger on the spray gun to relieve pressure in the hose.
CAUTION: Do not disconnect hose or gun under pressure
How to Use the Nozzles
CAUTION! NEVER exchange nozzles without locking the safety latch on the trigger (figure 2). The
quick–connect on the nozzle extension allows you to switch between several different nozzles. Each
nozzle provides a unique spray pattern and can work to better clean in different situations:
1) Engage the safety latch on the spray gun.
2) Pull back the collar on the quick–connect and pull the current nozzle off. Store the nozzle in the
space provided on the cart.
Nozzle Selection:
0 DEGREE- BLASTING
· Removing caked on mud from heavy construction, farm or lawn equipment.
· Cleaning tar, glue or stubborn stains from concrete.
· Cleaning overhead areas.
· Removing rust from steel and oxidation from aluminum.
15 DEGREE- STRIPPING
· Removing paint from wood, masonry or metal.
· Removing grease or dirt from equipment.
· Removing heavy mildew stains.
· Removing marine growth from boats and marine equipment.
· Removing rust from steel and oxidation from aluminum.
25 DEGREE- CLEANING
· General cleaning of dirt, mud and grime.
· Cleaning roofs, gutters and downspouts.
· Removing light mildew stains.
· Removing algae and bacteria build-up from pools.
· Rinsing surfaces in preparation for painting.
40 DEGREE- WASHING
· Light cleaning and washing.
· Washing and rinsing of automobiles and boats.
· Cleaning roofs, windows, patios and driveways.
Figure 2