Qualcraft UltraPro Aluminum Guardrail System - Manual (Page 2)

operational safety
metal conducts electricity:
Do not use this equipment where contact may be made with power lines or other live electrical circuits.
failure to understand and folloW all safety rules and assembly instructions could result
in serious inJury or deatH.
read before beginning assembly.
All photos and drawings in this booklet are for reference purposes only. Refer to applicable OSHA codes and regulations for the proper use of this equipment.
operation and safety
A scaffold must be erected, altered, and dismantled by qualified workers or under the direct supervision
of a qualified person. The qualified person must ensure that the installation is carried out properly, and that the correct
components and materials are being used.
Inspect before use. Do not use scaffold if damaged or parts are missing.
Always use outriggers and guardrails when stacking units.
The scaffold height must not exceed three times its smallest base dimension (3 to 1 rule).
Guardrails must be installed on all open sides of a working platform where a person could fall from a height of 6 feet
(1.8 meters) or higher. Check with federal, provincial/state and local codes for variances which may be more restrictive.
Guardrails must be installed so that gate swings inward over platform.
There must be a minimum of two side braces installed in each scaffold level and evenly spaced throughout the scaffold.
Lack of adequate bracing could cause scaffold to collapse.
Securely lock all braces and platform before each use.
Always use casters locked to the side frames with the locking pins. Lock all casters before climbing.
Erect to be plumb, level, rigid and square. Erect on firm, level ground.
Never place anything under or attach anything to unit to increase height or to adjust to uneven surfaces.
Acids are corrosive and can seriously affect strength. Do not expose unit to corrosive substances.
Keep scaffold free of debris and unnecessary equipment.
Do not climb scaffold unless scaffold has been levelled and all casters are locked.
Never move a rolling scaffold when people are on it.
assembly instructions
1 Erect the scaffold (one or two frames high) by following the manufacturer instructions.
2 Install the first guardrail panel by inserting two corner pegs into sockets in scaffold sides braces and secure
with lock pins. Be sure that guardrail gate swings inward over the platform.
3 Install the second guardrail panel by inserting two corner pegs into sockets in scaffold sides braces and secure
with lock pins. Be sure that guardrail gate swings inward over the platform.
4 Insert four lock pins in alignment with the scaffold side brace holes to keep the guardrails in place. Make sure
that the two guardrail panels are secure and can’t be lifted up.
box contents
QTY. DescriPTion
2 Guardrail panels
4 Locking-pins
2
3
4
1