Qualcraft Corner Buddy Ladder Stabilizer - Manual (Page 2)

ALUMINUM LADDER STABILIZER
Model #2470
LADDER
ACCESSORIES
Instructions for the care and use of the
Model #2470 Corner Buddy Ladder stabi-
lizer:
Capacity: The Corner Buddy Ladder Stabi-
lizer is designed to support one person to
maximum of 275 pounds.
Installation: First install bumpers on open
ends of tubing by fully seating the rubber
cup over the square tubing. Second, Us-
ing the hardware provided, install the ladder
stabilizer as pictured between the fi rst and
second rungs from the top of the ladder.
Do not install below the second rung or the
ladder may become unstable. The U-bolts
should capture the side rungs of the ladder
and then the stabilizer. Place the fl at con-
nector plate over the two threaded ends
of the U-bolt and secure in place with the
wing nuts. Insure that the ladder stabilizer
is positioned on the inside of the ladder,
between the ladder and the work surface.
Make sure the ladder stabilizer is centered
on your ladder.
Use: Read all warnings and instructions on
the ladder before using. Follow the ladders
instructions by setting the angle of the lad-
der against a vertical wall at 75.5 degrees.
Place the bottom of the ladder out from the
work wall 1⁄4 of it’s working height. Make
sure that the ladder is fi rmly supported at
the bottom and top. If using an extension
style ladder check to insure that the locking
mechanism is fully engaged before climb-
ing. To prevent an unstable situation, stand
at least 4 ladder rungs below the corner
buddy, never reach beyond the stabilizer
itself. Do not use as a support for planks.
Do not attempt to stand on ladder stabi-
lizer. Do not use near electrical equipment,
aluminum will conduct electricity.
Customer Supprt and Ordering In for ma tion
781-344-1000 • www.qualcraft.com