Qualcraft Tool Lanyard with Mini Carabiner - Manual

Guardian Tool Lanyards
w/ Twist Locking Carabiner
Product item #: 10725
w/ Mini Carabiner
Product item #: 10726
! DANGER
Guardian Tool Lanyards MUST NEVER be
used for Fall Protection of any kind.
ONLY attach carabiner to harness web strap. NEVER tie knots in Guardian Tool Lanyards.
NEVER connect multiple Guardian Tool Lanyards to each other.
NEVER remove product labeling.
Maintenance, Cleaning, and Storage:
Proper care is important for maintaining the safety and longevity of Guardian Tool Lanyards. Before and after each use,
remove all dirt, corrosives, and other contaminants from Guardian Tool Lanyards. If Guardian Tool Lanyards cannot be
cleaned with plain water, use mild soap and water, then rinse and wipe dry, or allow to dry in an environment absent of
excessive heat and light. When not in use, store equipment where it will not be affected by heat, light, excessive moisture,
chemicals, or other corrosive elements.
Do not throw away these instructions!
Read and understand these instructions before using equipment!
Instruction Manual
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
ti
on
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
! WARNING ALWAYS take extreme caution when operating or working near active machinery.
Length (including carabiner): 32”
Web Diameter: 1/2”.
Materials: polyester, nylon, and aluminum.
MAXIMUM capacity: 20 pounds.