DataComm 70-0070 10 Port Phone Module - Manual

2/25/08 Rev. 1
Instruction / Installation Sheet
DataComm Electronics 10 Port 110 Style Punch-Down Telephone Module 70-0070
Installation
 Align the mounting pins with holes in the back of the HCC panel and lock module into
place.
 Install the cable from the telephone company demarcation point to the 110 IDC connector
marked from Telco.
 Install twisted pair cables from each location in the house to the remaining 110 IDC
connectors. Match the color-coding of the wires to the colors on the 110 IDC connectors.
 The wires should be punched down, using an industry standard punch-down tool, to the
110 IDC connectors following the T568A wiring configuration as shown below.
 The RJ31x port is used to install the security line.
 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
CAUTION
 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
 Never touch un-insulated wires or terminals unless the telephone line has been
disconnected at the network interface.
 Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.
 Do not use this product near water, for example near a bath tub, wash bowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.
 SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
ETL LISTED
CONFORMS TO
UL STD 1863
ANSI/UL STD 60950-1
CERTIFIED TO
CAN/CSA STD C22.2 NO 60950-1
3026001