LumaSense Technologies Pearl Control - Manual (Page 31)

Pearl Control Software Manual Using Calibrate Tab Features 31
4.4 Replacing Pixels
Certain pixels in a camera may exhibit different behavior than other pixels and may show up
after performing a gain map. These pixels can be replaced to develop a higher quality image.
To find which pixel to replace, the image display box will display the location of the cursor as
well as the pixel value.
Pixel Replacement Screen
4.4.1 Selecting an Image for Pixel Replacement
In order to use the Pixel Replacement feature you will first need to add the image you would
like to replace pixels in. See Section 3.2 Capture an Image.
The Pixel Replacement screen provides a number of features: Image Source, Image Crosshair,
Image Colormap, and Camera Crosshair.
Image Source
The Pearl Control Software allows you to select four different types of images: Main Image,
Offset Map, NUC Map, and Gain Map.
To add the image from the Capture tab to the Pixel Replacement Image Display Box:
1. Click on the Calibrate Tab.
2. Click on Pixel Replacement.
3. Click the dropdown box under Image Source to select Main Image.
Image
Display Box