Vapamore MR-75 Amico - Manual (Page 9)

REFILL / CLEANING / STORAGE
GO TO VAPAMORE.COM TO SEE THE MR-75 AMICO INSTRUCTIONAL VIDEO
WARNING: Hot steam may escape when opening the cap if the machine is not
!
CLEANING / MAINTENANCE
IMPORTANT :
Always ensure before cleaning or maintaining the Vapamore MR-75 Amico that it is
unplugged from the wall outlet. Only clean the outer surface with a slightly, water
moistened cloth. Do not use any cleaning agents, abrasives or alcohol
Fig. 17
Lubricate the threads on the water tank cap with light oil or lubricating spray such as
WD-40 once every 3 months or when needed. R
The tank should be emptied before storing for any
extended period of time (30 days or more). To empty
the tank, make sure the MR-75 is completely cooled
upside down to drain any remaining water from the
is completely dry. Fig. 17
STORAGE
The included small cotton covers can be machine washed using normal detergents
and wash cycle.
The tank must be filled up when the steam flow emitted starts to decrease. Turn off
the MR-75 Amico by unpluging from the wall outlet. The red operation pilot light will
be off. Allow the unit to cool down for at least 15 minutes. Press the steam trigger to
release any remaining steam pressure. Open the tank cap by pressing down and turning
counter - clockwise.
Add water using the measuring cup / funnel then carefully close the tank cap again by
pressing down and turning clockwise untill fully tight. The MR-75 Amico can now be
plugged in. The unit is ready for use as soon as the red pilot light turns to green.
When storing the MR-75 Amico, unplug from the wall outlet and let
the unit cool down. After the unit has cooled, hold the steam trigger down to release
any steam pressure remaining.