Video Mount Products FP-LDSB User Manual
Page 3
Step 1
Before starting, lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
Step 2
Connect the desired amount of wall plates together using the
connector plates and nylon nuts .
Step 3
Mark the wall or desired mounting surface in preparation of installa-
tion of wall plate
(#1)
. If mounting to wooden studs, pre drill pilot holes
using a 7/32” drill bit. Attach the wall plate
(#1)
to the wooden stud
using the 5/16” by 2.5” long lag screw
(#36)
and washer
(#7)
mak-
ing sure the small ear fl aps are on the top rail of the wall plate
(#1)
.
WARNING: Please verify that your mounting surface will support the
combined weight of your mount, mounting hardware, and fl at panel.
Also verify that the mounting surface is safe to drill through. Please
note only mounting hardware for mounting to wooden studs will be
provided with the unit. If mounting to a surface other than wooden
studs then other hardware will be required. If in doubt or uncertain
about any of the above, please contact a professional installer.
Step 4
Attach the end caps to the ends of the wall plates using the
nylon nuts .
Step 5
If you need to extend the rails for mounting the fl at panel display in
portrait then proceed with the following step. Otherwise proceed to
the next step.
Attach extension A and extension B using the nylon nuts .
Step 2: Connect the wall plates
together
Step 3: Mounting the wall plates
Step 4: Attaching the end caps
Step 5: Attaching the extensions
1
1
15
2
12
13
11
1
15
3
1
1
36
7