Video Mount Products PRM-2 - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-
ed that the installation of this mount be done by a professional.
Step 2
Assemble the front pad by taking both of the rails B and place
them horizontally so that the fl aps with the slots cut into them point-
ing towards each other and are touching the ground. Then take
two rails A and place them on top of the left most slots cut into
the rails B so that the rail A slots mate up with the rail B slots
and so that the rail A’s fl aps are pointing towards each other. Do
the same for the right most slots on the rails B. Join the four rails
together with the square neck screws , lock washers and
nuts .
Step 3
Assemble the rear pad by taking both rails D and placing them
horizontally with the longer fl aps down and pointing towards each
other. Take a rail C and place it so the fl ap with the slots cut in
is pointing out from the well and so that the fi rst and third slots mate
with the slots in the rails D. Do the same for the other side and use
the square neck screws , lock washers and nuts to join
the four rails together.
Step 4
Connect the two sets of pads together using the hex head 5/16”
screws , lock washers and nuts .
Step 2: Assembling the front
wells
Step 3: Assembling the
rear well
Step 4: Connecting the
front and rear wells
4
2
7
1
6
2
3
8
7 6 8
7
9 8