Vitrex LRS600IND - Manual (Page 5)

Page 5 of 8
6.1 Installation
- Unfold the machine and fasten the handle.(See Fig.1-1,Fig1-2 and Fig1-3). Strip the machine by the
opposite actions.
Fit the screw to the groove; Lock on by fastening block; Finish installation;
Strip the machine by the opposite actions.
NOTE: If find the fastening block too tight or to loose to lock the handle, please adjust the fitting
screw to be looser or tighter by hand!
-Stick the sanding paper to the pad(Fig.2)
Ensure the holes on the sanding paper to fit the holes on the pad accuracy.
-Medium length installation
Loose the screw nut (Fig. 3-1) by anti-clockwise turning
and extend the length.
Then fasten the screw nut by clockwise turning (Fig.3-2).
Go back to the non-extended status by opposite actions.
--The longest length installation
Insert the additional handle to the end of the machine. And
then turn the screw nut on the end of the machine for
tightening. (Fig.4)