Asus P/I-XP6NP5 - Manual (Page 17)

ASUS P/I-XP6NP5 User’s Manual 11
III. INSTALLATION
III. INST
ALLA
TION
(Jumpers)
7. Voltage Regulator Output Selection (JP1, 2, 3, 4)
Pentium Pro Processors may require different voltages. Current processors
(marked "Pentium Pro") support VID and will automatically adjust the voltage
regulator so that no jumper settings are needed (leave these jumpers open in this
case). Older processors without VID support require manual voltage ID setting.
Use [S] for Short and [O] or Open.
Voltage 3.5 3.4 3.3 3.2 3.1 3.0 2.9 2.8 2.7 2.6 2.5 2.4 2.3 2.2 2.1
JP1 (VID 3) [S] [S] [S] [S] [S] [S] [S] [S] [O] [O] [O] [O] [O] [O] [O]
JP2 (VID 2) [S] [S] [S] [S] [O] [O] [O] [O] [S] [S] [S] [S] [O] [O] [O]
JP3 (VID 1) [S] [S] [O] [O] [S] [S] [O] [O] [S] [S] [O] [O] [S] [S] [O]
JP4 (VID 0) [S] [O] [S] [O] [S] [O] [S] [O] [S] [O] [S] [O] [S] [O] [S]
Voltage ID 3, 2, 1, 0 (VID Support or Manual)
VID Support (Default)
JP1 (VID 3)
JP2 (VID 2)
JP3 (VID 1)
JP4 (VID 0)
8. 3.3Volt Power Source (JP6)
If the ATX power supply is equipped with +3.3V, then choose ATX, some sup-
ply. If the ATX power supply is not equipped with +3.3V, then choose Onboard
Regulator. Move all three jumpers together as illustrated.
3.3V Power Source JP6 JP6 JP6
Onboard Regulator [1-2] [1-2] [1-2]
ATX Power Supply [2-3] [2-3] [2-3] (Default)
+3.3V Power Source (Regulator or ATX Supplied)
Regulator +3.3V
JP6
1
2
3
ATX +3.3V
JP6
1
2
3