In-Situ Extra Large Desiccant for Use with RuggedCable Systems - Manual (Page 2)

800-446-7488 2 www.in-situ.com
Connections
1. Remove the protective dust cap from the desiccant pack connector. Retain the cap
for later use.
2. Remove the small desiccant (if present) from the intended connector.
3. Attach the Extra Large Desiccant to the connector. If the connector is a twist-lock,
ensure you twist the textured sleeve over the desiccant until it clicks.
4. Remove the tape covering the two hydrophobic membranes of the desiccant pack.
Desiccant Guidelines and Precautions
l
The soft red dust caps protect connectors and shield new desiccant from moisture
prior to use. Do not remove the dust caps until you deploy the system. During
installation, remove caps to allow air to reach the cable vent.
l
Do not inhale the silica dust when pouring desiccant from one container to
another.
l
Indicating desiccant is blue when dry. It gradually turns pink as it becomes
saturated.
Desiccant stages (from left)
New, nearly expired (replace now), expired
l
Replace desiccant before the entire volume has turned pink.
l
Desiccant absorbs moisture from the top down. The black cap indicates the top.
Remember, replace desiccant before it expires to prevent
electronic damage to your instrument.