Brother PT-2100 - Manual (Page 60)

LABEL PRINTING
54
Tape Cutting Options
z
Tape Cutting
z
Setting Description Example
Large
Margin
Automatically cuts the tape after each label is
printed. The labels have a 0.94" (24 mm)
margin on the left and right ends.
Small
Margin
• When printing labels one at a time:
Automatically cuts a piece of blank tape
before printing the label, and then cuts the
tape after the label is printed.
• When printing several labels continuously:
Automatically cuts a piece of blank tape
before printing the first label, and then cuts
the tape after each label is printed.
• The labels have a 0.16" (4 mm) margin on
the left and right ends.
Chain
• When printing labels one at a time:
Automatically cuts a piece of blank tape
before printing the label, and then does not
cut the tape after the label is printed.
• When printing several labels continuously:
Automatically cuts a piece of blank tape
before printing the first label, and then cuts
the tape after each label is printed.
• The labels have a 0.16" (4 mm) margin on
the left and right ends.
• The tape is not fed and cut after the last
label is printed.
No Cut
• Use this setting to print a strip of labels with
no cuts in between.
• Pressing the while holding down
key will feed and cut the last label
printed.
ABC ABC
0.94"
(24 mm)
0.94"
(24 mm)
ABC ABC
0.16"
(4 mm)
0.16"
(4 mm)
0.92" (23 mm)
ABC ABC
0.16"
(4 mm)
0.16"
(4 mm)
0.92" (23 mm)
ABC ABC
1.06"
(27 mm)
0.31"
(8 mm)
• When using Fabric Iron-On Tapes or Extra Strength Adhesive Tapes, set “No Cut” and refer
to “Feeding Tape” on page 22 to apply the appropriate setting.
• The tape is not cut after the last label is printed when “Chain” or “No Cut” is set. Hold down
the key and press the key, and select “Feed & Out” (refer to “Feeding Tape” on
page 22 ) to feed and cut tape automatically, or cut the tape manually if you are using Fabric
Iron-on Tapes or Extra Strength Adhesive Tapes.
• When using the Auto-Format function, the label is cut with a margin on the left and right ends
regardless of the current Tape Cutting Option Setting except as “No Cut” is set.