HP Matrix Operating Environment Software - Manual (Page 40)

# each managed nPartition where you want to take advantage of iCAP. Also,
# each nPartition must meet the requirements outlined in the online help
# topic "Getting the most out of gWLM" as well as in the section "USING
# nPars AS COMPARTMENTS IN AN SRD" in the gwlmxml(4) man page on HP-UX or
# the gwlmxml(5) man page on Linux.
#
com.hp.gwlm.platform.icap.manageWithIcap = on
#
# Set the minimum number of Temporary Instant Capacity (TiCAP) minutes
# that must be available for TiCAP activation. gWLM will stop using
# TiCAP when the available balance goes below this threshold. The
# same value should be set on all agents managing the SRD. To use
# TiCAP, it must be available on the complex and enabled at the policy
# level or the SRD level.
#
com.hp.gwlm.node.ticap.minimumBalance = 30
Communications ports
gWLM uses the following ports for communications:
Managed nodes: 9617
CMS: 9618
If you need to change these ports, add the following lines:
com.hp.gwlm.cms.port = portX
com.hp.gwlm.node.port = portY
to both properties files:
•
gwlmcms.properties
On HP-UX, this file is in /etc/opt/gwlm/conf/. On Windows, it is in C:\
Program Files\HP\Virtual Server Environment\conf\
. (The given Windows
path is the default; however, a different path might have been selected at installation.)
•
/etc/opt/gwlm/conf/gwlmagent.properties
The portX and portY values cannot be the same value.
The com.hp.gwlm.cms.port property must have the same portX value in all the properties
files—across all managed nodes and on the CMS. Similarly, the com.hp.gwlm.node.port property
must have the same portY value in all the properties files—across all managed nodes and on the
CMS.
You must restart gwlmcmsd and gwlmagent for the changes to take effect. If you are using gWLM
through System Insight Manager, you must also restart System Insight Manager. (On HP-UX, restart
Ststem Insight Manager daemons using /opt/mx/bin/mxstop and mxstart. On Windows,
restart the HP Systems Insight Manager service.)
NOTE: Restarting gwlmcmsd temporarily disables HP Matrix OE visualization and
HP Capacity Advisor.
Controlling gWLM’s startup behavior
The gWLM CMS daemon or service (gwlmcmsd) is set to start at boot by vseinitconfig.
Generally, you should not change this setting as it disables all HP Matrix Operating Environment
from starting at boot.
40 Additional configuration and administration tasks