Allocating unallocated hdd space for an hp image – HP EliteBook 8560w Mobile Workstation User Manual
Page 34
5.
When you are notified that the array migration has completed, close all open programs and
restart the computer. When the computer is restarted, the operating system detects the newly-
created array and prompts you to restart the computer a second time.
6.
After you have restarted the computer a second time, the RAID migration is complete.
NOTE:
Although the total capacity of the RAID 5 volume appears in the Console, the extra capacity
created with the addition of the three HDD’s appears to the system as unallocated space. After the
system reboots, you must allocate the unallocated space. For Windows XP, the only option through
the operating system is to create and format a separate volume. Windows Vista and Windows 7
contain additional capabilities that allow you to create a single RAID 5 volume. Refer to
unallocated HDD space for an HP image on page 30
for further instructions.
Allocating unallocated HDD space for an HP image
If you want one continuous C: partition for RAID 0 and RAID 5, you must allocate the unallocated
space after the system reboots for the final time. You can create an additional partition, or you can
extend the (C:) partition. In order to extend the (C:) partition, you must move the Extensible Firmware
Interface (EFI) and Recovery partitions using the following procedure. The EFI partition stores
QuickLook, system diagnostics, and BIOS Flash Recovery files. The Recovery partition contains files
that allow you to restore the computer to the factory image.
NOTE:
If the functionality of the EFI and Recovery partitions is not required, these partitions can be
deleted.
In Windows XP:
1.
After the system reboots, select Start, right-click My Computer, and then click Manage from the
drop-down menu.
2.
In the left pane under Storage, click Disk Management. The Disk Management window displays
the unallocated space and two partitions: (C:) and HP_TOOLS.
3.
Right-click the Unallocated capacity, and then select New Partition from the drop-down menu.
The New Partition Wizard opens.
4.
Click Next.
5.
Select Primary Partition, and then click Next.
The partition size defaults to the maximum.
6.
Click Next.
7.
Assign a drive letter, and then click Next.
8.
Select the NTFS format, enter the volume name, and then click Next.
9.
Review your selections, and then click Finish to complete the formatting.
In Windows Vista and Windows 7:
1.
Select Start, right-click Computer, and then click Manage from the drop-down menu. The
Computer Management window displays.
30
Chapter 5 RAID volume setup