HP Designjet T2500 eMultifunction Printer series - Manual (Page 190)

8. Remove the paper left in the printer.
9. Make sure you have removed every fragment of paper.
10. Lower the scanner and close the roll cover.
11. Restart the printer by holding down the power button for a few seconds, or by turning the power switch
at the rear off and then on.
12. Reload the roll, or load a new sheet see Paper handling on page 50 .
NOTE: If you find that there is still some paper causing an obstruction within the printer, restart the
procedure and carefully remove all pieces of paper.
The paper has jammed in the stacker
When a paper jam is detected in the stacker, printing is paused, and the front panel asks you to open the
stacker cover and clear the jam by pulling out the paper.
180 Chapter 20 Troubleshooting paper issues ENWW