HP XP P9500 Storage - Manual (Page 115)

Corrective action Description Path status
The secondary system's S/N
does not match the specified
S/N. Serial Number Mismatch • Make sure that you entered the correct secondary system S/N and
Controller ID, and primary and secondary system port numbers.
•
Make sure the primary and secondary system ports are configured
correctly.
• Make sure that data path relay equipment is properly configured
and functional. This includes cables, connectors, switches, extender
devices, communication lines, and all other devices connected to
the extenders.
The specified port is not
configured as an initiator Invalid Port Mode •
Make sure the correct port on the primary system is configured as
an initiator port.
port, or this path already
exists.
• Make sure that no two paths between primary and secondary system
ports have the same settings.
•
Make sure that you entered the correct secondary system S/N and
Controller ID, and primary and secondary system port numbers.
• Make sure that the primary and secondary system ports are
configured correctly.
•
Make sure that data path relay equipment is properly configured
and functional. This includes cables, connectors, switches, extender
devices, communication lines, and all other devices connected to
the extenders.
The specified port in the
secondary system is physically Pair-Port Number
Mismatch • Make sure that you specified the correct secondary system port
number. Correct the port number if necessary.
disconnected from the primary
system.
•
Make sure that the cables between the primary and secondary
system ports and between the primary and secondary system
switches are connected correctly.
•
Make sure that the topology settings of the primary and secondary
system ports are correct.
Make sure that the secondary system port is configured as an RCU
target port. The specified secondary
system port is not configured
as an RCU target port. Pair-Port Type Mismatch
The primary system is
connected to the secondary Communication Failed • Make sure that the secondary system port and the relay equipment
are configured correctly.
system successfully, but
•
Make sure that data path relay equipment is properly configured
and functional. This includes cables, connectors, switches, extender
logical communication timeout
occurred.
devices, communication lines, and all other devices connected to
the extenders.
Wait until processing is completed. Paths are being created or
deleted, or the port attribute
is being changed. In Progress
See the following. Blockaded due to continual
path or link failure. Logical Blockade
Repair the port on the primary system, then restore the path
*
. The primary system port does
not work.
Repair the port on the secondary system, then restore the path
*
. The secondary system port
does not work.
Repair the path relay equipment, then restore the path
*
. The path relay equipment
does not work.
Replace the broken cable, then restore the path
*
. The connection cable is
physically broken.
Restore the path
*
. A program error is detected. Program Error
Troubleshooting logical paths 115