HP StoreEasy 3000 Gateway Storage - Manual (Page 29)

Figure 11 SAS/SATA hard drive LEDs
.
Table 7 SAS and SATA hard drive LED combinations
Status 2. Online/activity LED
(green) 1. Fault/UID LED (am-
ber/blue)
The drive has failed, or a predictive failure alert has
been received for this drive; it also has been selected
by a management application.
On, off, or flashing Alternating amber and blue
The drive is operating normally, and it has been se-
lected by a management application.
On, off, or flashing Steadily blue
A predictive failure alert has been received for this
drive. Replace the drive as soon as possible.
On
Amber, flashing regularly (1
Hz)
The drive is online, but it is not active currently. On Off
Do not remove the drive. Removing a drive may
terminate the current operation and cause data loss.
The drive is part of an array that is undergoing ca-
pacity expansion or stripe migration, but a predictive
failure alert has been received for this drive. To
minimize the risk of data loss, do not replace the
drive until the expansion or migration is complete.
Flashing regularly (1 Hz)
Amber, flashing regularly (1
Hz)
Do not remove the drive. Removing a drive may
terminate the current operation and cause data loss.
The drive is rebuilding, or it is part of an array that
is undergoing capacity expansion or stripe migra-
tion.
Flashing regularly (1 Hz) Off
The drive is active, but a predictive failure alert has
been received for this drive. Replace the drive as
soon as possible.
Flashing irregularly
Amber, flashing regularly (1
Hz)
The drive is active, and it is operating normally. Flashing irregularly Off
A critical fault condition has been identified for this
drive, and the controller has placed it offline. Re-
place the drive as soon as possible.
Off Steadily amber
X3000 G2 Network Storage System User Guide 29