HP X1000 Network Storage Systems - Manual (Page 14)

Check kit contents
Remove the contents, making sure you have all the components listed below. If components are missing,
contact HP technical support.
• HP StorageWorks X1000 or X3000 Network Storage System (with operating system preloaded)
• Power cord(s)
• Safety and Disposal Documentation CD
• HP StorageWorks Storage System Recovery DVD
• End User License Agreement
• Certificate of Authenticity Card
• Slide rail assembly
• HP ProLiant Essentials Integrated Lights-Out 2 Advanced Pack
Locate and record the serial number
Before completing the installation portion of this guide, locate and write down the storage system's
serial number.
The storage system's serial number is located in four places:
• Top of the storage system
• Back of the storage system
• Inside the storage system shipping box
• Outside of the storage system shipping box
Install the storage system hardware
1. Install the rail kit by following the HP Rack Rail Kit installation instructions.
2. If connecting to the storage system using the direct attach method, connect the following cables
to the back panel of the storage system in the following sequence: keyboard, mouse, network
cable, monitor cable, and power cable.
NOTE:
• The keyboard, mouse, and monitor are not provided with the storage system.
• The X1600 does not include PS/2 ports for connecting a keyboard and mouse. You
must use USB-compatible keyboard and mouse devices with this storage system.
3. If connecting to the storage system using the remote management method, connect a network
cable to a data port, a network cable to the iLO 2 port, and power cable.
Access the storage system
Use either the direct connect or remote management method to connect to the storage system.
Installing and configuring the storage system 14