HP LE2001w 20-inch Widescreen LCD Monitor - Manual (Page 14)

Connecting the Cables
WARNING! To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one may
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the
electrical outlet, grasp the cord by the plug.
LE1851w, LE1851wl, LE2001w, and LE2001wl Models
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Connect the VGA signal cable to the VGA connector on the rear of the monitor and the other end
to the VGA connector on the computer.
3. Connect one end of the power cable to the AC power connector on the back of the monitor, and
the other end to an electrical wall outlet.
Figure 3-4 Connecting the Cables
4. For cable management, place the cables between the two hooks at the lower section of the
pedestal base. The cables can be neatly secured and hidden when viewed from the front.
6 Chapter 3 Setting Up the Monitor ENWW