AMD ATHLON 8 - Manual (Page 52)

40 Electrical Data Chapter 8
AMD Athlon™ XP Processor Model 8 Data Sheet 25175H—March 2003
Preliminary Information
T
BIT
Input Time to Acquire 20.0 ns 7, 8
T
RPT
Input Time to Reacquire 40.0 ns 9–13
T
RISE
Signal Rise Time 1.0 3.0 V/ns 6
T
FALL
Signal Fall Time 1.0 3.0 V/ns 6
C
P IN
Pin Capacitance 4 12 pF
T
VALID
Time to data valid 100 ns 14
Table 16. General AC and DC Characteristics (continued)
Symbol Parameter Description Condition Min Max Units Notes
Notes:
1. Characterized across DC supply voltage range.
2. Values specified at nominal V
CC_CORE
. Scale parameters between V
CC_CORE.
minimum and V
CC_CORE.
maximum.
3. I
OL
and I
OH
are measured at V
OL
maximum and V
OH
minimum, respectively.
4. Synchronous inputs/outputs are specified with respect to RSTCLK and RSTCK# at the pins.
5. These are aggregate numbers.
6. Edge rates indicate the range over which inputs were characterized.
7. In asynchronous operation, the signal must persist for this time to enable capture.
8. This value assumes RSTCLK period is 10 ns ==> TBIT = 2*fRST.
9. The approximate value for standard case in normal mode operation.
10. This value is dependent on RSTCLK frequency, divisors, Low Power mode, and core frequency.
11. Reassertions of the signal within this time are not guaranteed to be seen by the core.
12. This value assumes that the skew between RSTCLK and K7CLKOUT is much less than one phase.
13. This value assumes RSTCLK and K7CLKOUT are running at the same frequency, though the processor is capable of other
configurations.
14. Time to valid is for any open-drain pins. See requirements 7 and 8 in the “Power-Up Timing Requirements“ chapter for more
information.