HP ProCurve 520wl Wireless Access Point - Manual (Page 93)

CLI Command Types
6-10
example 5 - show the group parameters example 5 - show the group parameters example 5 - show the group parameters example 5 - show the group parameters
In this example you can view all elements of a group or table.
Syntax:
[Device Name]>
show <group name>
Example:
[Device Name]>show network
Result: The CLI displays network group parameters. Note show network and show ip return the same data.
Figure 6-9 Figure 6-9 Figure 6-9 Figure 6-9 Results of “show network” and “show ip” CLI Commands Results of “show network” and “show ip” CLI Commands Results of “show network” and “show ip” CLI Commands Results of “show network” and “show ip” CLI Commands
example 6 - show individual and table parameters example 6 - show individual and table parameters example 6 - show individual and table parameters example 6 - show individual and table parameters
1. View a single parameter.
Syntax:
[Device Name]>show <parameter name>
Example:
[Device Name]>
show ipaddr
Result: Displays the Access Point IP Address.
Figure 6-10 Figure 6-10 Figure 6-10 Figure 6-10 Result of “show ipaddr” CLI Command Result of “show ipaddr” CLI Command Result of “show ipaddr” CLI Command Result of “show ipaddr” CLI Command
2. View all parameters in a table.
Syntax:
[Device Name]> show <table name>
Example:[Device Name]> show mgmtipaccesstbl
Result: Displays the Access Point IP Access Table and its entries.